| Part No. | Features | Number of Channels | Vcc (V) Min | Vcc (V) Max | Icc (uA) TYP. | Icc (uA) Max | VD (V) | ID (mA) | Vsub (V) | Package |
| L4002 | 4 Channels FET Bias Controller * Built in FET device protection circuit * Stable bias control for GaAs and HEMT FETs * Drive up to four FETs * 2.5V supply voltage | 4 | 2.375 | 2.625 | 6 | 10 | 2 | 9.5 | -2 | SOP-16 |
| L8400 | 4 Channels FET Bias Controller * Can Bias up to 4 FETs * Drain Current Adjustable by Two External Resistors. * Two Sets of Drain Current can be Setted. | 4 | 5 | 12 | - | 15 | 2.2 | 10 | -3 | SSOP-16 (150mil) |
| L8401 | 4 Channels FET Bias Controller * Can Bias up to 4 FETs * Drain Current Adjustable by Two External Resistors. * Two Sets of Drain Current can be Setted. | 4 | 3.3 | 6 | - | 10 | 2 | 10 | -2.5 | SSOP-16 (150mil) |
| L8402 | 4 Channels FET Bias Controller * Can Bias up to 4 FETs * Wide supply voltage range: 3V~8V * Low quiescent supply current, 1.2mA typical * FET drain voltages set at 2.0V * Adjustable FET device operating current * FET drain voltages and currents held stable over temperature and VCC variations * Built in FET device protection circuit * Low external component count | 4 | 3 | 8 | 1.4 | 4 | 2 | 9.5 | -2.65 | QFN-16(3X3) SSOP-16 |
| L8403 | 4 Stage FET LNA Bias Controller * Provides Bias for up to 4 GaAs and HEMT FETs * Operating Range of 2.1V to 5V * Ultra-low Operating Current of 0.95mA * Dynamic FET Protection * Amplifier FET Drain Voltages set at 2.0V * Regulated Negative Rail Generator Requires only 1 External Capacitor * Expended Temperature Range of -40°C to +105°C | 4 | 2.1 | 5 | 0.95 | 2 | 2 | 10 | -2.0 | QFN-16(3X3) |
| L8600 | 6 Channels FET Bias Controller * Can bias up to 6 FETs * Drain current adjustable by two external resistors. * Two sets of drain currents can be set. | 6 | 5 | 12 | - | 15 | 2.2 | 10 | -3 | SSOP-20 (150mil) |
| L8602 | 6 Channels FET Bias Controller * Low quiescent supply current, 1.6mA typical * Six stage FET bias controller, two configurable as mixer stages * Operating range of 3.0V to 8.0V * Amplifier FET drain voltages set at 2.0V, mixer drain voltage set at 0.25V * Amplifier FET drain current selectable from 0 to 15mA, mixer current from 0 to 7.5mA * Switchable FET’s for power management * FET drain voltages and currents held stable over temperature and VCC variations * FETs protected against overstress during power-up and power-down. * Internal negative supply generator allowing single supply operation (available for external use) * Low external component count | 6 | 3 | 8 | 1.6 | 4 | 2 | 10 | -2.65 | QFN-20(4X4) |
| L8001 | 6 Channels FET Bias Controller * Built in FET device protection circuit * Adjustable FET device operating current * Stable bias control for GaAs and HEMT FETs * Drive up to six FETs * Wide supply voltage range | 6 | 3.3 | 6 | - | 10 | 2 | 10 | -2.5 | SSOP-20 (150mil) |
| L8002 | 6 Channels FET Bias Controller * Built in FET device protection circuit * Stable bias control for GaAs and HEMT FETs * Drive up to six FETs * 2.5V supply voltage | 6 | 2.375 | 2.625 | 6 | 10 | 2 | 9.5 | -2 | SSOP-20 (150mil) |
| L8020 | Dual Polarsation Switch Twin LNB Multiper Controller * Avoid external components * Provides polarity detection and control * Temperature compensated input threshold * Normal and inverted output available while wide supply operating range * Simplify the design | 2 | 5 | 12 | - | 10 | - | - | - | SOP-8 MSOP-8 |
| L8012 | Dual Tone and Polarity Switch For LNB Multiper Controller *Dual channels multiplexing with low external component counts. | 2 | 5 | 8 | 9 | 12 | - | - | - | SSOP-16 (150mil) |
| L8312 | Dual Polarization and Tone Switch Controller * Direct Drive PIN Diode and Multiplexer IC * High Supply Voltage | 2 | 5 | 9 | 10 | - | - | - | - | SSOP-16 |
| L8200/A | Single LNB-Bias, Control And Power Management Solution. * Single chip LNB bias, control and power management * Integrated regulated supply for LNB * Zero Gate FET switching * Voltage detection for polarization switching * 22kHz tone detector with signal rejection for band switching * Programmable mixer and FET bias | 4 | 8V | 22V | 2 | 3 | 1.95 | 9.5 | -2.4 | TSSOP-16 QFN-16(3x3) |
| L8211 | 3 Channels FET Bias Controller With Polarization Switch and Tone Detection * Three outputs that can drive up to 3 FETs. * Drain current adjustable by external resistor. * HB and LB switch for LNBs. * Band switching by 22kHz tone detection. | 3 | 5 | 10 | 6 | 15 | 2 | 10 | -3 | SSOP-20 (150mil) |
| L8113 | 3 Channels FET Bias Controller With Polarization Switch and Tone Detection * High-accuracy voltage detection circuit * Two types of cell-balance function: charge/discharge * Control charging, discharging, cell-balance by CTLC,CTLD pins * Low current consumption: 8.0μA max | 3 | 5 | 10 | - | 15 | 2.2 | 10 | -3 | SSOP-20 (150mil) |
| L8115 | 3 Channels FET Bias Controller With Polarization Switch and Tone Detection * Can bias up to 3 FETs * HB and LB switch for LNBs. * Drain current adjustable by external resistors. * Band switching by 22KHz tone detection. | 3 | 5 | 10 | 8.5 | 15 | 2.2 | 10 | -2.8 | SSOP-16(150mil) SSOP-20(150mil) |
| L8221 | Single LNB–Bias, Control and Power Management Solution * Single chip LNB bias, control and power management * 22kHz tone detector with signal rejection for band switching * Zero Gate FET switching * Voltage detection for polarization switching * Programmable mixer and FET bias * Temperature compensated protected FET bias | 2 | 8 | 22 | 2 | 3 | 2 | 10 | -2.5 | HSOP-8 |
| LB8102 | DiSEqC Switch IC * Single supply voltage 3.9V~5V. * Support DiSEqC 1.0/ 1.1 and Tone Burst commend * Selectable 4x1 and 2x1 application. * Drives up to four switches. * Position and option witch commend. * SOP8 surface mount package | 4 | 3.9 | 5.5 | 0.15 | 0.3 | - | - | - | SOP-8 |
